ELICA Hidden Guia do Utilizador descarregar pdf (Página 12)

Grease filter

Fig. 17-19

Traps cooking grease particles.

This must be cleaned once a month (or when the filter

saturation indication system – if envisaged on the model in

possession – indicates this necessity) using non aggressive

detergents, either by hand or in the dishwasher, which must

be set to a low temperature and a short cycle.

When washed in a dishwasher, the grease filter may discolour

slightly, but this does not affect its filtering capacity.

To remove the grease filter, pull the spring release handle.

Charcoal filter (filter version only)

Fig. 18

It absorbs unpleasant odours caused by cooking.

The charcoal filter can be washed once every two months

using hot water and a suitable detergent, or in a dishwasher at

65°C (if the dishwasher is used, select the full cycle function

and leave dishes out).

Eliminate excess water without damaging the filter, then put it

in the oven for 10 minutes at 100° C to dry completely.

Replace the mattress every 3 years and when the cloth is

damaged.

Installation or replacement of the charcoal filter

1. Open the perimeter suction panel

2. Remove the grease filter.

3. Insert the charcoal filter pad inside the two rear tabs, so that

it adheres to the grid for engine protection

4. Block it using the holding grid that is to be installed with the

two fixing side screws.

Note: Proceed in reverse order when disassembling.

5. Reposition the grease filters

6. Close the perimeter suction panel

Replacing lamps

The hood is equipped with a lighting system based on LED

technology.

The LEDs guarantee an optimum lighting, a duration up to 10

times as long as the traditional lamps and allow to save 90%

electrical energy.

For replacement, contact the technical service.

1 2 ... 7 8 9 10 11 12

Sem comentários

ELICA Hidden Guia do Utilizador Página 12